Let us see how to wear the sensor before connecting the sensor to the app
Before Taking Session:
Wear the strap around the chest and adjust its tightness accordingly. Ensure that the strap is in proper contact with your body.
To attach the sensor to the strap. Align the pair of metal screws against the pair of metallic contacts on the strap. Gently press until you hear a ‘click’ on each of the contacts.
Please refer to the video for reference.
Note The Netrin logo should be pointed upwards as shown in the picture below.
After The Session:
Detach the sensor from the strap and take off the strap from your body. Removing the sensor from the strap improves battery life.
Rinse the strap under running water and hang to dry. Alternatively, the strap could be cleaned using a dry cloth and sanitiser. Clean the strap after every session to maintain quality data collection.
Note- The strap in rare cases may cause mild rashes depending on your skin sensitivity. If rashes appear, a moisturiser or baby oil could be applied to the contact areas.
If your Netrin sensor is already connected to the app, then you're all set.
However, if your sensor isn't registered yet, just follow the simple steps below,
Before registering the sensor, the app shall ask for a few permissions. Please,
Turn on the Bluetooth
Turn on the mobile data
Allow location access
2. Sensor Registration
There are two easy ways to register your Netrin sensor:
From Home Screen
From the Menu
From the Home Screen:
Simply click the 'Register New Sensor' button right on the home screen.
From the Menu:
Alternatively, you can access the 'Sensor Details' section by clicking the 'Hamburger (≡) menu' located at the top-left corner of the home screen. From there, you can register your sensor with ease.
After this, the app will initiate the scanning process for the ‘Available sensors’.
To make your Netrin sensor discoverable, simply touch the pins located on the back side of the sensor.
Each Netrin sensor has a unique 12-digit ID number, which can be found on the back of the sensor.
Look for this 12-digit ID in the list of Available sensors, and then simply connect or "pair" with it.
Once the connection is established successfully, you'll see the 'Go Live' button on the home screen from where you can start taking the sessions.